magnitude of stress中文是什么意思

• 应力值

• "magnitude"中文翻译    n. 广大，巨大；伟大，重大，重要性；大小；积；量；【数 ...
• "stress"中文翻译    n. 1.压力，压迫，紧迫，紧张。 2.【语音】重音；重 ...
• "magnitude of maximum shearing stress" 中文翻译 :    最大剪应力值
• "magnitude of self-stress" 中文翻译 :    自应力
• "magnitude" 中文翻译 :    n. 广大，巨大；伟大，重大，重要性；大小；积；量；【数学】量值；【天文学】(恒星的)等，等级，光度。 magnitude equation 【天文学】星等差。 magnitude of eclipse 【天文学】食分。 of the first magnitude(星的光度)(第)一等的；最大的；最重要的(人物等)。
• "earthquake magnitude, magnitude" 中文翻译 :    震级
• "stress" 中文翻译 :    n. 1.压力，压迫，紧迫，紧张。 2.【语音】重音；重读；【诗】扬音；语势，着重点。 3.重要(性)，重点，强调。 4.【物理学】应力；胁强，重力。 The landlord has imposed a severe stress on the poor tenants. 房东给贫苦的房客们加了很大的压力。 We must lay stress on self reliance. 我们必须强调自立更生。 Give stress to the 2nd syllable. 重读第二音节。 stress diagram 【工业】应力图。 moisture stress 缺水。 tensile stress 【材】抗张应力。 be stressed out (因心理压力过重而)精疲力尽的。 driven by stress of＝under stress of. in times of stress 在紧张[繁忙，困难]的时候。 lay [place, put] stress on 强调，用力干，着重于。 under stress of 被…逼迫着，在…强制下，由于，因为。 vt. 1.着重，强调，加重语气说。 2.用重音读。 3.加压力[应力]于，压，压迫。 adj. -ful ,-less adj.
• "stress on" 中文翻译 :    对…的强调
• "the stress" 中文翻译 :    搭配的单词
• "absolute magnitude" 中文翻译 :    【天文学】绝对星等。
• "ac magnitude" 中文翻译 :    交流幅度
• "amplify the magnitude of" 中文翻译 :    扩大...的重要性
• "apparent magnitude" 中文翻译 :    蓝等; 视星等
• "astronomical magnitude" 中文翻译 :    开文数值
• "average magnitude" 中文翻译 :    平均量
• "b-magnitude" 中文翻译 :    蓝星等
• "balance magnitude" 中文翻译 :    设置平衡数量
• "be of the right magnitude" 中文翻译 :    大小正好合适
• "bodywave magnitude" 中文翻译 :    体波震级
• "bolometric magnitude" 中文翻译 :    热星等
• "condition on magnitude" 中文翻译 :    幅值条件
• "constant magnitude" 中文翻译 :    不变量
• "construction of magnitude" 中文翻译 :    大型建筑
• "current magnitude" 中文翻译 :    电恋
• "dc magnitude" 中文翻译 :    直流幅度

• However , the magnitude of stress should exceed a correspond value , if the stress has the ability to improve the flaw extending
  但是就应力幅来讲，据保守的计算，也只有当应力幅值达到一定的数值后，才可能促使裂纹扩展。
• According to the paper , the reason of influencing the flaw progress has three factors , that is , the magnitude of stress , material and the mode of flaw
  分析表明决定裂纹从萌生扩展到临界裂纹(这时裂纹发生失稳扩展)的扩展过程的主要因素有三个：应力幅值大小、材料、裂纹模式。
• The reliability ' s construe result for the magnitude of stress , and the flaw length and the life of flaw extend will be helpful to the modernization administration for the portal crane
  对应力幅、临界裂纹长度及裂纹扩展寿命的可靠性分析所得出的结论对以后的港口机械的现代化管理有一定的理论和实践指导意义。
• Methods : this experiment used finite element analysis ( fen ) in the design of mesial and distal occlusal rest of distal - extension partial removable denture and to test the magnitude of stress and displacement of abutment teeth and soft tissue under the base when under the vertical force of two conditions
  方法：采用有限元法在末端游离缺损义齿的有限元模型上作远中、近中（牙合）支托设计，分别在人工牙及修复后的牙列（包括义齿及基牙）上作垂直向加载，测试基牙及基托下软组织的位移及应力值，通过测试结果作对比分析。
• The research indicate that the structured soft clay has below several characteristic , the viscous strain is produced during the stage of primary consolidation and of second consolidation , and in the prophase , the relation of stress - strain - strain rate is unique , so the form of constitutive model , such as , f ( v ' , e ) = 0 , f ( ' v , e , t ) = 0 , ca n ' t describe strain behavior of soil skeleton rationally ; the time - dependent properties involve three aspects , in addition the time - dependent strain , apparent preconsolidation pressures that depend on strain rate , and the effect of creep compression on apparent preconsolidation pressures ; because of holding structural strength , the mechanics characteristic is determined by the magnitude of stress , and the compression curve is composed of several sections . by combining structural yield stress and it ' s characteristics with the improved time line model , a new one - dimensional elastic visco - plastic consolidation model is established
  研究结果表明，结构性土的固结过程具有以下特性：主固结和次固结阶段都包含有因土骨架的粘滞性移动而产生的变形，而且在正常固结阶段，存在应力?应变?应变速率的唯一性， f ( _ v ， e ) = 0 、 f ( _ v ， e ， t ) = 0形式的本构关系不足以描述土骨架的变形行为；固结压缩过程中的时间效应包括三个方面的内容，除了应力应变关系与时间相关外，还包括粘滞性变形引起表观前期固结压力增加和屈服应力的应变速率效应；软土的结构性使其力学特性与应力水平相关，压缩曲线具有分段性。
• The principal stress value arised alteration , the magnitude of stress closed to 25 ~ 32mpa , its influence scope was within the scope outside of tunnel opening 10 ~ 15 meter , maximum tense focused at vault and middle of floor about half meter . shearing stress focused at corner of vault and wall , always been sheared
  主应力量值也发生了较大改变，压应力可达25 32mpa ，其影响范围在隧道边墙外10 15m ；拉应力集中在拱顶和底板中部约0 . 5m范围内，最大可达10mpa ；在拱腰和墙脚常为剪应力集中区，易发生塑性剪切破坏。
• In generally , there is specially mode of flaw in the specially place , this phenomenon is caused by the structure of the crane and the running mode of the crane . the characteristic of the material and the length of the limiting flaw aflcct the bearing ability of the crane . and the magnitude of stress affects the extending velocity
  一般来讲，港口装卸机械的特定部位有特定的裂纹模式，这主要是由机械设备结构及其运行所决定，而材料则决定了构件所能承受的强度及其承载能力和临界裂纹的长度范围，而应力幅则决定了裂纹的扩展速度。